Production and processing of stone vanity

According to the customer sample or the production of the vanity order requirements to select the appropriate block of the original stone, it is best to knock on a block of samples to polish control, observe the pattern, color and particles are consistent. If it is conventional thickness of the countertop can also be a large board market direct procurement of large plates. The choice of choice is to choose the same color, the same pattern, the same particles, close to the density of the block or large board, while the appearance does not allow cracks, stone gallbladder, color lines, flowers and so on defects. Purchase a large vanity at the same time pay attention to the thickness and size.

Large cutting vanity

Is in accordance with the customer's processing requirements with a circular saw or sand saw the cutting process into the process of the slab. After cutting a test to be carried out, qualified to retain the board, unqualified pick out, for the thick hair plate for post-processing. (If it is a big board, you can skip this stage.)

Polished and polished stage of coarse grinding and fine grinding two parts.

Rough grinding vanity panel: the front of the process of qualified products and thicker of the board with a polisher first rough grinding, the current mill is mainly used to drive mill and long continuous grinding and polishing machine. After drying, check the board, the board effect is good, you can directly fine grinding, if the board is not ideal plate quality, can be on the surface of the board brushing, brush on a layer of resin will be Its hair plate above the small holes and small cracks, chicken feet and other defects make up, but also can make the board of the board better, higher gloss.

In the case of good weather, the resin is generally more than half an hour can be dry, if the weather is not good, almost 1-2 hours will be dry, it is best to dry and then fine grinding. And some factories are not rough grinding, wash check the board, and then directly on the board (problematic) on the brushing. Usually less granite brush, marble brush more.

Fine grinding vanity panel: with a polisher will be qualified wool board or repair the board by block polished into a light plate, remember to make the light can not repair the cracks, light, stone gallbladder, sweeping and other defects with The red crayons are marked on the board so that the next process can be found in time to avoid these defects for processing small size components such as flaps or thicker edges.

Often the order of the European and American orders to meet the requirements of more than 90 ° (or in accordance with customer requirements processing, if part of the stone can not meet the requirements and customer consultation). At the same time Europe and the United States standard wool plate flatness limit tolerance of 0.8MM, thickness limit tolerance to allow positive and negative tolerance 1MM.

From：vanity